agent failed to complete flag deal risk signals in a renewal call error failure

TL;DR

Resume the run for flag deal risk signals in a renewal call from its last completed stage instead of restarting it, first fixing the input the run log names as missing or invalid for that stage, because the agent stopped partway and left the task half done (a summary without its destination write, or extracted items never saved), and a clean restart repeats the same stop. Start with the renewal call transcript risk segments and the Chorus risk flags, and the agent run log for the step where it stopped, work on one affected call, record, or run first, and prove the fix there before running the full set. Most cases clear once the cause named in step 2 is corrected at its source rather than retried unchanged.

agent failed to complete flag deal risk signals in a renewal call error failure

Use this when

• You see this exact message or symptom: agent failed to complete flag deal risk signals in a renewal call error failure
• One run, record, call, or object is affected and you can name it
• A retry without changing anything reproduces the same result

Not for this skill when

• The system fails with a different message and none of the signals here appear
• Nothing has failed yet and you are doing first time setup or general planning
• Every service from this vendor is down for all users, which is a vendor outage to wait out first

Steps

1. Reproduce the failure once using the renewal call transcript risk segments and the Chorus risk flags, and the agent run log for the step where it stopped, and record the time, the workspace or account, and the one item it names. Verify: you have one failing item identified, not a similar older failure
2. Inspect the renewal call transcript risk segments and the Chorus risk flags. Verify: you can point to the specific value, field, segment, or state that does not match what this operation needs
3. Apply the fix at that source: Resume the run for flag deal risk signals in a renewal call from its last completed stage instead of restarting it, first fixing the input the run log names as missing or invalid for that stage, because the agent stopped partway and left the task half done (a summary without its destination write, or extracted items never saved), and a clean restart repeats the same stop. Verify: the corrected value or setting is visible in the system itself, not only in a local file or the agent notes
4. Re-run the original operation on the single affected item first. Verify: that one item completes with no trace of the failure described above, and every budget, sponsor, or timeline risk phrase in the transcript has a matching flag with its segment quoted
5. Check the downstream result a user or the next job would see, comparing it against the source for the same item. Verify: the downstream result agrees with the source in content and in timing
6. Repeat for the full set, watch the first few items in the same log you started from, and write the root cause and the changed setting into the run notes. Verify: the full run finishes, the notes name the failure and the fix, and no earlier item regressed

Variant phrasings

agent failed to complete flag deal risk signals in a renewal call error failure

The subject-first phrasing of the same failure. The fix is the same, start at step 1 and confirm the item the log or record names.

Tool-first phrasing of this failure

The phrasing searchers use once they know which system raised it. It is the same underlying problem, not a separate bug.

Why does this keep happening after a retry

The repeat-occurrence phrasing. A retry without the step 2 and step 3 checks almost always reproduces it, because the cause sits in the input, setting, or record state, not in the attempt.

Compatibility: Chorus exports and API at current versions, plus the CRM or sharing destination the task names; the steps assume the run can be resumed per call rather than only as a whole batch.

Why it happens

Agent runs fail at stage boundaries: a missing call id, an export that had not finished, or a destination record that was locked. The run reports a generic failure, the partial output sits unused, and nothing records which stage succeeded, so the next attempt cannot tell done from not done.

Provenance

Resolved from the public thread: https://vectle.com/posts/pst_h8Y-leDyuSuVPrWc4cR7sw