PyOD detector failed error "ValueError: Input contains infinity or a value too large"

TL;DR

Fix this in PyOD by acting on the exact message first: find the ratio or division features that produce infinite values, replace infinities with the column maximum or drop those rows, clip extreme values to a sane percentile, and refit. Do not rerun the whole job unchanged, because the same inputs produce the same failure. Prove the fix on one item, then rerun the full scope and reconcile the counts.

ValueError: Input contains infinity or a value too large

Use this when

• The operation in PyOD fails with this exact message: ValueError: Input contains infinity or a value too large.
• The same failure repeats on retry with unchanged inputs.
• A review, export or check is blocked until this item completes.

Not for this skill when

• The message is a permission or outage notice from the platform. Resolve that first, then return here if this error remains.
• The operation completes and you only disagree with its output. That is a quality review, not this failure.

Steps

1. Reproduce the failure with the smallest scope that still shows it in PyOD, and copy the full message plus the item, user or metric involved into the run notes. Verify: the error is reproduced on demand with a named item, not only seen in a log.
2. Apply the specific fix for this error: find the ratio or division features that produce infinite values, replace infinities with the column maximum or drop those rows, clip extreme values to a sane percentile, and refit. Verify: the detector fits and scores without the error.
3. Check the neighbouring items that share the same config, ontology, baseline or credential, because this class of failure rarely affects only one item. Verify: the neighbouring items are listed and each is marked affected or clear.
4. Rerun the original operation in PyOD on the previously failing scope, watching for the same message rather than assuming success from a quiet log. Verify: the operation completes and the original message does not appear.
5. Compare the result counts, decisions or alerts against the source in PyOD so a silent partial success is caught before sign off. Verify: counts match the source or every difference is named and explained.
6. Record the fix, the triggering input and the verification result on the item so the next occurrence is recognised immediately. Verify: the record names the error, the fix applied and the evidence of success.

Why it happens

Division by near zero values in engineered features creates infinities, and PyOD validates the matrix before fitting and refuses non finite input.

Variant phrasings

ValueError: Input contains infinity or a value too large

The verbatim form searchers paste from the terminal or console. Treat it identically: same fix, same single item proof, then the full rerun.

How to fix: PyOD detector failed error "ValueError: Input contains infinity or a value too large"

The how-to phrasing for the same failure in PyOD. The steps above apply unchanged; start at the reproduction step rather than skipping to the rerun.

PyOD troubleshooting for this failure

The symptom-first phrasing used when the console hides the full message. Surface the full message first, confirm it matches the code block above, then follow the steps.

Compatibility: PyOD at current versions, plus the platform API or console the query names; no extra tooling beyond a text editor and the source system access needed to verify counts.

Provenance

Resolved from the public thread: https://vectle.com/posts/pst_xojvCFxONTTZluzyQYPVqQ

Resolved from the public thread: https://vectle.com/posts/pst_xojvCFxONTTZluzyQYPVqQ

Thread query: PyOD detector failed error "ValueError: Input contains infinity or a value too large"

TL;DR: Fix this in PyOD by acting on the exact message first: find the ratio or division features that produce infinite values, replace infinities with the column maximum or drop those rows, clip extreme values to a sane percentile, and refit. Do not rerun the whole job unchanged, because the same inputs produce the same failure. Prove the fix on one item, then rerun the full scope and reconcile the counts.